I have inherited a myford super 7 lathe in bits this vid is about an initial inspection. Im not quite sure how to go about finding a suitable replacement.
Myford Super 7
Myford Super 7 Lathe Youtube
Myford Lathes Lathes For Sale Gumtree
Another distinguishing feature of early machines was the clutch contained within the countershaft 4 step cast iron pulley.
Myford super 7 specifications. The drive is motorised by a 055kw 34hp 230 volts 50hz. The super 7 connoisseur is a vari speed belt driven backgeared screwcutting bench mounted centre lathe 89mm 312 centre height x 475mm 1834. Line up the motor pulley to it and lock the grub screws which secure the motor pulley.
Spares counter myford connoisseur specifications of the connoisseur lathe specifications of the myford connoisseur lathe ref. Ive looked at the faceplate for the old motor though i dont think this was the original motor and tried to look up the model number or serial number without much luck. I have no prior knowledge and have not used a lathe since we did metalwork at school which for me was 45.
Im sorry that this is not a very exciting question and arguably it is in the wrong place but i dont know where else to put it. I am buying a myford super 7 lathe and would be very grateful to learn of its approximate weight and how best to transport it. Early version of the myford super 7.
Our purpose is to provide information about vintage machinery that is generally difficult to locate. The tailstock body can be set over on its base in either direction to turn long shallow tapers. Very early 1953 myford super 7 with the integral headstock drip feed oiler the circular window of which can be seen just to the left of the chuck this lubrication system was abandoned after a few years production.
General specification and comparison with the ml7 when it appeared in late 1952 it was immediately obvious that the super 7 although built with the same bed way dimensions as the ml7 was a thoroughly re engineered design with many significant improvements. Is it beyond the strength of two men to lift it into a reasonably sized estate car. But do not secure.
P using a straight edge held firmly against the countershaft pulley. The tailstock is a self ejecting type and the barrel feedscrew has a three start thread to give rapid movement. The super 7 was produced in 1953 as an improved version of the original myford ml7 lathe.
Some photos and data on my myford super 7 lathe. The barrel is precision bored 2 mt. There were several updates the obvious being the re designed headstock the longer cross slide and the increased diameter leadscrew.
The motor on our myford super 7 lathe has burned out and needs to be replaced. Myford super 7 3y centre lathe 0 place the motor pulley in position on the motor shaft with the large step outwards. Specifications of the myford sigma lathe.
Myford Ltd Home Page British Engineering At Its Best
Reformado Myford Super 7 Lathe Alimentacion Con Caja De Engranajes
Myford Super 7