website hit counter

Tung Oil Over Minwax Stain

In Wood 70 views

Repeat at 24 hour intervals for a total of 4 6 coats for a nice gloss. This is my second stock doing this and previously i used 5050 mineral spirits and pure tung oil for about 3 coats followed by a coat of pure tung oil.

Introduction And Bolt Kit Question Kieselguitarsbbs Com

Adventures In Staining Butcher Block What Worked And What Did Not

Watco Danish Oil Vs Polyurethane For Wood Finishing Home Guides

The first couple of coats seal up the wood and subsequent coats build up a hard finish on the surface.

Tung oil over minwax stain. Wipe or brush on a generous coat of minwax tung oil. Be sure the stain has completely dried before applying the finish. How to apply a tung oil topcoat over an oil based wood stain.

The results where good. Let sit on wood for approximately 5 10 minutes then buff evenly with a clean lint free cloth. Then you will want to use a tung oil based topcoat applied over an oil based stain when you are staining or refinishing your special piece of furniture.

However it does require some upkeep. Then make a sample from a chunk of poplar put some holes in it fill them with the putty and test some stains on the sample to see how the putty accepts the stain. Tung oil is an easy to use transparent finish that is resistant to water most liquids and mildew.

Combine the tung oil with a quality interior varnish i prefer not to use polyurethane though ive heard a few people do. Minwax tung oil finish. You can choose between gloss and satin depending on the look you want.

Wait 24 hours and apply a second coat. However i recently saw an image of a fellow online that used minwax gunstock stain and his grains really popped. Rub the finish into the wood with the steel wool let it sit for about three minutes and then wipe off the excess with a lint free cloth.

You can vary the proportions using as much as 34 tung oil or 34 varnish again depending on the look you want. And i am assuming here that you are using minwaxs tung oil finish which is not a traditional tung oil the best solution is to sand the poplar cabinet until the finish is gone. Apply in the direction of the grain.

3 Tricks For A Beautiful Walnut Wood Finish Woodworkers Source Blog

Minwax Tung Oil Finish Specialty Products

Minwax Tung Oil Finish Oil Based Wood Finish Minwax

Tags: #tung oil over minwax stain

No related post!
Must read×

Top